Jeep Part Inquiries Members are looking for:

I need various parts for a 1990 Wrangler. I am looking to refurbish this vehicle. Need Seats, Top, Chrome Accs, OEM door parts etc

JEEP BODY (TUB) IN GOOD COND.

plastic zip up window for a half door on the passenger side

I must rebuild the engine of my 1986 Jeep Grand Wagoneer and need parts. Any help is appreciated!

Need bellhousing: 258ci, 10 1/2 clutch, T-18 4spd Tran

Looking for engine, trans(5manual) and transfer case. Currently have a 4 cylinder but could option to install a 6 cylinder. Low miles perfered. Please contact by phone or e-mail.

WANTED: USED STEELHORSE SUPER SEATS GREY IN GOOD CONDITION.

complete a/c unit from 92-95 yj. dash unit,compressor,hoses,condenser.also one pair of factory side steps from 97-up wrangler.

173 (2.8L) V6 full engine or any other compatable engine. ie no major modifications needed, prefer if mounting points match. New or remanufactured engines prefered.

DAYNA 44 REAR END WITH 3.73 GEARS

I need a frame for a jeep wrangler.

manual 5-speed transmission

looking for a hard top with or without doors for a 92 jeep wragler yj

RIGHT SIDE ELECTRIC MIRROR FOR 1991 JEEP CHEROKEE.

Looking for a 3inch lift,drag link and Tie rods Steering Gear,

I am looking for a 4.0L high output head to replace my 4.2L head on my 1984 CJ. I would also be interested in maybe whole upper assembly (fuel injection intake manifold and exhaust manifold).

Fuel tank for a 1952 M38A1 jeep

Carpet for a 1983 J10 pick up.(Black)

LINKAGE FOR DANA 300 TRANSFER CASE. I NEED THE BRAKET THAT CONNECFDTS THE SHIFTER AND SHIFT RODS ON T-CASE

Yes i am looking for a brake booster with power brakes.

Need driver seat bottom cushion. Grey Vinyl.

Soft top for my 1997 Jeep TJ

Looking for suspension lift 4 to 6 inches.

Looking for tires 33 to 35. Also 4 rims to fit tires.

i need a rear driveshaft with u-jionts

i need a rear driveshaft with u-jionts

seats for my jeep. both front and back.

I need a rear seat complete for any 1997 through 2002 Jeep Wrangler. Any color, any condition. The frame must be complete. Thank you.

need only hood, for 1995 wrangler rio grande

I am looking to upgrade my air intake system and do not know which company to go with. I am running with the stock system and a K&N air filter and I am very happy with it so far, but I want more power and still better gas mileage!! I have been considering the K&N FIPK, the Rock-it air, and the Airaid system. If anyone has tried any of these or know which one is best, please let me know and if you have a price that would be helpful too. Thanks for the help!!

need PCM module part number 56027803. located inside drivers front fender under hood. must be 93 only(per dealer) need center dome housing with mounting bracket(inside car)

I am looking for a compressor for a 1995 Jeep Grand Cherokee Laredo

more jeep parts...